Detailed sailboat specifications and datasheets since 2015
MetricSI (m)
Imperial & Metricboth
ImperialIMP (ft)

X-512 (Standard)

Main featuresX-512 Standard
Model
X-512
Version
Standard
Hull type
Monohull
Category
Offshore cruiser-racer sailboat
Sailboat builder
X-Yachts
Sailboat designer
Country
Denmark
Construction
GRP (glass reinforced polyester):
Sandwich fiberglass polyester with galvanized steel frame
Number of hulls built
17
First built hull
1990
Last built hull
1995
Appendages
Keel : fin without bulb
Helm
Twin helm wheels
Rudder
Single spade rudder
Unsinkable
No
Trailerable
No
 
Main dimensionsX-512 Standard
Hull length
51’ 1”15.59 m
Waterline length
41’ 6”12.66 m
Beam (width)
14’ 10”4.5 m
Draft
9’ 2”2.8 m
Light displacement (MLC)
30111 lb13658 kg
Ballast weight
13228 lb6000 kg
Ballast type
Lead
 
Rig and sailsX-512 Standard
Upwind sail area
1698 ft²157.72 m²
Downwind sail area
2902 ft²269.64 m²
Mainsail area
702 ft²65.24 m²
Genoa area
995 ft²92.48 m²
Solent area
664 ft²61.65 m²
Symmetric spinnaker area
2200 ft²204.4 m²
Rigging type
Sloop Marconi masthead
Mast configuration
Keel stepped mast
Rotating spars
No
Number of levels of spreaders
3
Spreaders angle
0 °
Spars construction
Aluminum spars
Standing rigging
Single-strand (ROD)
 
PerformancesX-512 Standard
Upwind sail area to displacement
 iThe ratio sail area to displacement is obtained by dividing the sail area by the boat's displaced volume to the power two-thirds.

The ratio sail area to displacement can be used to compare the relative sail plan of different sailboats no matter what their size.

Upwind: under 18 the ratio indicates a cruise oriented sailboat with limited performances especially in light wind, while over 25 it indicates a fast sailboat.
297 ft²/T27.6 m²/T
Downwind sail area to displacement
 iThe ratio sail area to displacement is obtained by dividing the sail area by the boat's displaced volume to the power two-thirds.

The ratio sail area to displacement can be used to compare the relative sail plan of different sailboats no matter what their size.
508 ft²/T47.19 m²/T
Displacement-length ratio (DLR)
 iThe Displacement Length Ratio (DLR) is a figure that points out the boat's weight compared to its waterline length. The DLR is obtained by dividing the boat's displacement in tons by the cube of one one-hundredth of the waterline length (in feet).
The DLR can be used to compare the relative mass of different sailboats no matter what their length:

a DLR less than 180 is indicative of a really light sailboat (race boat made for planning), while a DLR greater than 300 is indicative of a heavy cruising sailboat.
191
Ballast ratio
 iThe Ballast ratio is an indicator of stability; it is obtained by dividing the boat's displacement by the mass of the ballast. Since the stability depends also of the hull shapes and the position of the center of gravity, only the boats with similar ballast arrangements and hull shapes should be compared.

The higher the ballast ratio is, the greater is the stability.
44 %
Critical hull speed
 iAs a ship moves in the water, it creates standing waves that oppose its movement. This effect increases dramatically the resistance when the boat reaches a speed-length ratio (speed-length ratio is the ratio between the speed in knots and the square root of the waterline length in feet) of about 1.2 (corresponding to a Froude Number of 0.35) . This very sharp rise in resistance, between speed-length ratio of 1.2 to 1.5, is insurmountable for heavy sailboats and so becomes an apparent barrier. This leads to the concept of "hull speed".
The hull speed is obtained by multiplying the square root of the waterline length (in feet) by 1.34.
8.64 knots
 
Auxiliary engineX-512 Standard
Engine(s)
1 inboard engine
Engine(s) power (min./max.)
62 HP / 100 HP
Fuel type
Diesel
Fuel tank capacity
84.5 gal320 liters
 
Accommodations and layoutX-512 Standard
Cockpit
Closed aft cockpit
Cabin(s) (min./max.)
3 / 5
Berth(s) (min./max.)
6 / 12
Head(s) (min./max.)
3 / 4
Freshwater tank capacity
150.6 gal570 liters
Fridge/ice-box capacity
76.6 gal290 liters
Boiler capacity
5.3 gal20 liters
Maximum headroom
6’ 5”1.95 m
 
Boat-Specs.com uses cookies to improve user experience. By using our website you consent to all cookies in accordance with our Cookie Policy.

Read more